☎

Connection schemas for my Arduino.

IMU

Arduino Transistor1 IMU
5 V 1 VIN
GND 3 GND
A3 2  
A4   SDA
A5   SCL2

Camera, Sync mock setup

Use the Button example sketch and connect as in that sketch. Instead of the LED, use the signal cable. When you don’t have a button with you, use a separate wire and a condensator to avoid bouncing. Switch between +5V and GND to change the signal.

  1. Pins counted as with the flat side towards me. ↩

  2. Cable got detached and this is my best bet. I should test this. ↩